Solution to failure of car out of control of Fedar sublimation printer

October 16, 2020

In process of Fedar sublimation printer, there will always be various failures. Here, Fedar sublimation printer manufacturer will tell you what to do if Fedar sublimation printer’s car out of control?
Car Out of Control Fedar sublimation printer
Many customers responded that car suddenly ran to side when Fedar sublimation printer is running, or that car suddenly hit side of track when Fedar sublimation printer was turned on. It will seriously damage car and printhead. Below, Fedar sublimation printer explains how we should solve this situation.


First of all, this failure is generally caused by failure of driver board and encoder sensor and so.

1.Check whether encoder sensor of Fedar sublimation printer is damaged, whether encoder strip can be detected normally, if not, you can replace it with a new encoder sensor.

2.We must first check whether signal line of servo motor of Fedar sublimation printer is connected properly, whether there is bad connection or short circuit. If signal cable is faulty, it is recommended to replace it with a new signal cable.

3.If all signal cables are connected properly, we can check whether driver board and main board are normal. If there are signs of burnout or short circuit, it is recommended to replace new driver board and main board of Fedar sublimation printer.

Fedar Sublimation Printer

Zhengzhou New Century Digital Technology Co., Ltd.,- (Fedar a high-tech enterprise specializing in research, manufacture, sale and service of sublimation printer,digital textile printer ,inkjet heat transfer printing machine and related consumables.


By cooperating with world famous printhead manufacturers and software suppliers, we integrate exquisite and practical technology into our products. Up to now, fedar printer has independently developed a series of mature products.

Fedar Sublimation Printer Factory