Events

Fedar heat transfer printer stopped suddenly during printing

September 08, 2020

Fedar heat transfer printer stopped suddenly while printing, and the software displayed normal output information. When this happens, most staff do not know what caused it, nor do they know where to start troubleshooting.

Fedar Heat Transfer Printer Stopped Suddenly During Printing

The following fedar heat transfer printer analyzes and solves this problem:

 

1. Check the ground wire: because static electricity will have a bad effect on signal transmission, connect the standard ground wire to ensure that fedar heat transfer printer has a good grounding.

 

2. Check whether the connectors at both ends of fedar heat transfer printer's printing cable are in poor contact. Replace the power cord and data cable to eliminate the problems of both. It is recommended that the printing cable should not exceed 3 meters. Too long will also affect the accuracy of data transmission;

 

3. Set the computer print port correctly, it is recommended to set it to network printing, the advantage is to greatly reduce the error of data transmission. If there is no network port, check whether the computer has been set to use the ECP printer port;

 

4.Sometimes the computer configuration will also affect the rendering effect, and the disk space needs to be processed regularly.

 

If you have any problems that cannot be solved, you can directly contact sales or technical personnel for help.

Fedar Heat Transfer Printer